A4 Sedan L4-2.0L Turbo (BPG) (2005)
Power Trunk / Liftgate Lock Actuator: Service and Repair
Lid Lock and Handle Mechanism, Removing and Installing
Lid Lock And Handle Mechanism, Removing And Installing
1. Rear lid lock
-
To remove, unclip operating rod from swivelling bush and disengage.
-
Unscrew hex nuts - 3 - and remove rear lid lock.
2. Swivelling bushing
-
After installing rear lid lock, engage operating rod and secure.
3. Nut
-
8 Nm
4. Operating rod
5. Bowden cable
6. Lock cylinder
-
Removing
-
Disconnect electrical harness connectors.
-
Disengage Bowden cable - 6 - from lock cylinder.
-
Remove combination bolt - 7 -.
-
Twist lock cylinder 90 degrees.
-
Remove lock cylinder from handle mechanism.
7. Combination bolt
-
8 Nm.
8. Engine
9. Grip piece