A4 Sedan L4-2.0L Turbo (BPG) (2005)
Headlamp Control Module: Service and Repair
High Intensity Gas Discharge (HID) Lamp Control Module J343 / J344, Removing and Installing -
Through 10.04
High Intensity Gas Discharge (HID) Lamp Control Module J343 / J344, Removing And Installing - Through 10.04
CAUTION:
-
HIGH VOLTAGE!
-
Always disconnect negative (-) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE"
warning symbols.
Removing
-
Remove headlamp.
-
Remove screws - arrows -.
-
Remove control module -1- from housing cover for headlamp housing.
-
Disconnect electrical connections -1- and - 2 -.
Installing
Install in reverse order of removal, noting the following:
-
Check gasket between control module for HID headlamp bulb and headlamp housing.
-
Install headlamp.
-
Reconnect battery. Required steps.
Tightening torque
Component - fastener
Nm
Control module to headlamp - screw
1