A4 Sedan L4-2.0L Turbo (BPG) (2005)
-
Remove bolt - arrow - on rear of power steering pump.
-
Remove power steering pump.
Installing
Installation is performed in reverse sequence, note the following:
^
Replace gaskets and seals.
^
Before installing a new pump, put in hydraulic fluid at the inlet and turn pump by hand until fluid flows out at the pressure outlet.
^
Secure all hose connections with new hose clips. Parts catalog
-
Turn hub by hand until fluid comes out at pump outlet.
-
Install pump on bracket.
-
Install and tighten bolts - 1 -.
-
Tighten bolt - arrow - on back of power steering pump
-
Install new seals on banjo bolt.
-
Tighten banjo bolt for pressure hose.
-
Install intake hose. Installation position.
-
Bolt on power steering pump pulley.
-
Install ribbed belt.
Make sure the belt is properly seated in the pulleys when installing.
-
Install lock carrier.
-
Install bumper.
-
Install sound insulation.
-
Fill with hydraulic fluid G 002 000.
-
Start engine and check that belt runs properly.
-
Check hydraulic fluid level.