A4 Sedan L4-2.0L Turbo (BPG) (2005)
Clutch Switch: Service and Repair
Clutch pedal switch F36, removing and installing, 01X, 6 Spd. M/T FWD
Note:
^
Clutch pedal switch F36 may only be installed once so as to ensure a firm fit.
Removing
-
Remove storage compartment on drivers side.
-
Disconnect electrical connector -1- on clutch pedal switch.
^
The clutch pedal -3- is in the normal position (i.e. not pressed down). The operating rod - arrow - of the clutch pedal switch F36 should then
rest against the clutch pedal.
-
Release clutch pedal switch F36 -2- by turning 45° counter-clockwise and remove from guide.
Installing
Installation is perform in reverse sequence. Note the following:
-
Pull out operating rod -arrow- all the way before installing clutch pedal switch F36.
^
The clutch pedal should be in the normal position (i.e. not pressed down).
-
Guide clutch pedal switch F36 through mounting hole, press against clutch pedal and attach by turning 45° clockwise.
-
Plug in connector for clutch pedal switch F36.
-
Install storage compartment on drivers side.
Removing and installing clutch pedal starter interlock switch F194