A4 Sedan L4-2.0L Turbo (BPG) (2005)
/Page-2867002.png)
4 - Bolt for flywheel
^
Always replace
^
Observe instructions for removal
^
Bolt length: 22.5 mm; 60 Nm plus an additional 90° 1/4 turn
^
Bolt length: 43 mm; 60 Nm plus an additional 180° 1/2 turn
5 - Dual-mass flywheel
^
Make sure that dowel pins fit tightly
^
Contact surface for clutch lining must be free of grooves, oil and grease
^
Observe instructions for removal
6 - Needle bearing
^
Removing and installing
Identification
Pressure plate with stop mechanism (position sensor) - arrow
Checking ends of diaphragm spring
^
Wear up to half the thickness of the diaphragm spring is permitted.
Note:
^
When performing repairs, always select the correct clutch pressure plate and clutch plate by checking engine code.
