A4 Sedan L4-2.0L Turbo (BPG) (2005)
-
Install splitter (e.g. Kukko 15-17) into annular groove - arrow - on inner bearing race and tighten spindle.
-
Press inner bearing race off wheel hub.
Lightweight wheel hub
Pressing wheel hub (82 mm diameter) into wheel bearing
-
When pressing in thrust pad VW 511 must only rest on inner race.
Installing
-
Insert wheel bearing unit in wheel bearing housing.
-
Install and tighten countersunk bolts - 1 -.
-
Slide drive axle outer joint into wheel hub and tighten new hex bolt hand-tight.
Note:
^
Remove any remaining adhesive on thread of outer joint pin.