A4 Sedan L4-2.0L Turbo (BPG) (2005)
/Page-3061004.png)
-
Clamp flange shaft in vise, using jaw protectors. Use new circlip - A - to press old circlip out of groove in flange shaft.
-
Drive flange shaft in with needle bearing drift VW 295.
-
Bolt drive shaft to flange shaft
-
If applicable, bolt on heat shield for drive axle (left-side).
-
Fill transmission with oil and check oil level.
-
Install sound insulation.
Tightening torque
