A4 Sedan V6-2.8L (AFC) (1996)
-
Torx socket T40
-
Bolts are included in the repair kit for the brake pads
2. Brake disc
-
Always replace as a set on both wheels of an axle
-
Ensure adequate thickness
-
To remove, first unbolt brake caliper
-
Internally ventilated brake disc
-
Diameter: 245 mm (9.65 inch)
-
Thickness: 30 mm (1.18 inch)
-
Wear limit: 28 mm (1.10 inch)
3. Brake caliper
CAUTION:
-
Do not allow the caliper to hang by me brake hose. The unsupported weight can stretch and damage the hose.
-
Secure the brake caliper with a piece of wire in order to relieve the stress on the brake hose.
-
With the exception of replacing brake pads and servicing front brake calipers, no further repairs may be performed to the brake caliper
4. Clamping spring
5. Ribbed bolt
-
200 Nm (148 ft. lbs.)
-
Clean ribbing if re-using
6. Brake line
-
15 Nm (11 ft. lbs.)
7. Retaining spring
8. Harness connector
-
Only on models with wear indicators
9. Brake hose
-
Do not disconnect the brake hose from the caliper when replacing brake pads.
10. Bolt
-
25 Nm (18 ft. lbs.)
11. Bracket
-
Bolt to brake caliper housing
-
Install harness connector for brake pad wear indicator
12. Harness holder
-
Only on models with wear indicators
-
Install harness for brake pad wear indicator into harness holder
13. Brake pads
-
Always replace as a set on both wheels of an axle
-
Different left and right sides
-
Removing and installing; Refer to Brake Pads With wear indicator
-
Once wear limit is reached (3 mm, 0.12 inch), warning light in instrument panel comes on
-
Brake pad thickness: 14 mm (0.55 inch)
-
Outer pads have an adhesive with a protective sheet on the backing plate; remove this sheet before installing