A4 Sedan V6-2.8L (AFC) (1996)
/Page-986002.png)
CAUTION: Mark the direction of belt travel before removing, using a suitable marker. Reinstalling a used belt in the opposite direction could damage
the belt.
-
Remove ribbed belt.
-
Remove ribbed belt tensioner.
-
Unclip camshaft drive belt guard on both sides.
-
Turn crankshaft by hand to Top Dead Center (TDC) position.
^
Notch -A- must align with notch -B-.
NOTE: If not aligned, turn crankshaft one more revolution.
-
Check camshaft position.
^
Large holes in camshaft sprocket locking plates must face each other.
-
Remove Crankshaft Position (CKP) sensor from lefthand side of cylinder block, behind oil cooler (above oil pan).
^
TDC recess in crankshaft must be positioned behind open hole for CKP sensor (inspect visually or by touch).
Crankshaft Holder 3242 Shown In Installed Position
-
Thread crankshaft holding tool 3242 into CKP sensor hole, and tighten slightly.
-
Remove vibration damper.
-
Remove lower belt guard.
Camshaft Holder 3243 Shown In Installed Position
-
Install camshaft holding tool 3243.
-
Loosen left and right camshaft sprocket bolts approximately 3 turns.
