A4 Sedan V6-2.8L (AFC) (1996)
-
25 Nm (18 ft. lbs.)
9. Power steering pump bracket
10. Ignition coils with bracket
11. Socket head bolt
-
25 Nm (18 lbs.)
12. Banjo bolt
-
40 Nm (30 ft. lbs.)
13. Seals 16 x 22
-
Always replace
14. Seal 18 x 24
-
Always replace
-
6 cyl. 2V gasoline engine only
15. Line union
-
50 Nm (37 ft. lbs.)
-
Vehicles with V6 2V gasoline engine
-
Vehicles with power steering pump: FP-3
16. Clamp
-
Always replace
-
Use VAG1275 to tighten
17. Bolts
-
25 Nm (18 ft. lbs.)
18. Slotted bushing
19. Socket head bolt
-
25 Nm (18 ft. lbs.)
20. Bracket
21. Suction line with hose
22. Bolt
-
8 Nm (71 inch lbs.)
Removing
-
Unclip and remove engine cover refer to Fig. 1.
-
Unbolt and remove cover for ribbed belt refer to Fig. 2.
-
Loosen and remove ribbed belt refer to Fig. 3.
-
Counterhold belt pulley -5- using VAG1590 (if applicable) and remove.
-
Disconnect ignition wires from ignition coils -10-.
-
Pinch off suction hose using 3094 hose clamp.
-
Remove pressure and suction lines.
-
Unbolt bracket -9- and remove together with pump -4-.
-
Remove bolts mounting pump to bracket and remove pump.
Installing
-
Install in reverse order of removal.
Note: The ignition wires must be correctly reinstalled in the correct firing order refer to Fig. 4.
Fig. 1 Unclipping and removing top engine cover