A4 Sedan V6-2.8L (AFC) (1996)
Fluid - A/T: Testing and Inspection
Automatic Transmission Fluid (ATF) Level, Checking With Auxiliary Cooler
ATF level, checking (vehicles with auxiliary ATF cooler)
This test must be performed after auxiliary ATF cooler has been emptied or when it has been replaced.
Test requirements:
Transmission must not be in emergency running mode.
ATF is filled, refer to Automatic Transmission Fluid (ATF), Checking and Changing See: Automatic Transmission Fluid (ATF), Checking and
Changing
Selector lever in "P", let engine run at idle.
A/C system and heating switched off.
The ATF temperature is read out by the VAS5051 tester or VAG1551 Scan Tool (ST).
Checking ATF temperature
- Connect VAS5O51 tester to vehicle with VAS5O51/1 diagnostic wire. Alternately, VAG1551 Scan Tool (ST) can also be attached using
VAG1551/3 adapter.
- Start engine.
- When indicated on display:
- Press buttons -0- and -8- to select "Read measuring value block" and press -Q- button to confirm input.
- When indicated on display:
- Press buttons -0-, -0- and -4- to select display group "004" and press -Q- button to confirm input.