A4 Sedan V6-2.8L (AFC) (1996)
Control Module: Service and Repair
REMOVAL
-
Remove trim from right lower A-pillar (3 in illustration).
-
Remove right sill scuff molding (1 in illustration) in door area, refer to Body and Frame.
-
Loosen carpeting from right inner sill panel and raise approx. 20 cm (8 in.).
-
Unclip container at position (A in illustration) from top.
-
Unclip container at position (B in illustration) as shown.
-
Remove control module from container.
-
Loosen multi-point connector, then remove connector from control module, as follows.
-
Switch ignition off and wait approx. 30 seconds.
-
Push lock in direction of arrow and release connector
INSTALLATION
-
Install in reverse order, noteing the following additional steps:
-
Check container for water penetration, seal if necessary.
-
Check that clip nut (1 in illustration above) fits securely.
-
Check harness routing: