A4 Sedan V6-2.8L (AFC) (1996)
-
Examine left flange shaft for burrs and sharp edges at shaft end on transmission side -arrow- and deburr, if necessary.
-
Install left flange shaft into transmission.
NOTE: When installing the left flange shaft, guide it carefully by hand to avoid damaging the double seal in the transmission.
-
Check gear oil in final drive and top up, refer to Checking/Topping Up Oil Level.
-
Tighten the following components to:
Mounting bracket for left flange shaft to transmission: 23 Nm (17 ft lb)
Drive shaft to flange shaft: 80 Nm (59 ft lb)
Drive shaft to wheel hub:
14 mm stretch bolts (replace): 115 Nm (85 ft lb) + 90°
16 mm stretch bolts (replace): 190 Nm (140 ft lb) + 90°
Heat shield to transmission: 23 Nm (17 ft lb)