A4 Sedan V6-3.2L (BKH) (2007)
-
Remove backrest cover panel.
-
Disconnect electrical harness connector.
-
Disengage retaining bracket and remove actuator downward.
-
Installing:
Installation is performed in reverse order of removal, noting the following:
-
Actuator can only be installed in one position.
9
-
Central screws
For centering four-way lumbar support with frame
10
-
Rivet
11
-
Plastic washer
12
-
Four-way lumbar support height adjustment motor
Removing
NOTE: When replacing positioning motor, four-way lumbar support must not be on an end stop.
-
Remove backrest cover panel.
-
Disconnect electrical harness connector.
-
Disengage retaining bracket and remove actuator upward.
Installing
Installation is performed in reverse order of removal, noting the following:
-
Actuator can only be installed in one position.
13
-
four-way lumbar support
14
-
Fastening strips
15
-
Backrest padding
-
Through 06.06 (for specific countries)
-
Through 11.06 (rest of world)
Disconnecting electrical harness connector and disengaging retaining bracket at actuator
NOTE: When replacing positioning motor, four-way lumbar support must not be on an end stop.
-
Disconnect electrical connector - 4 -.
-
Disengage retaining bracket - 3 - using a screwdriver - 2 - and remove actuator - 1 -.