A4 Sedan V6-3.2L (BKH) (2007)
/Page-946001.png)
Piston: Locations
Piston and connecting rod, component overview
Note:
^
Oil injector jet for piston cooling
1 - Connecting rod bolt, 30 Nm plus an additional 90° (1/4 turn)
^
Replace
^
Lubricate threads and contact surface
^
Tighten to 30 Nm to measure radial play, do not turn further
2 - Connecting rod bearing cap
^
Do not interchange
^
Mark allocation to cylinder using a color marker - B -.
^
When installing bearing cap, observe: The wide thrust flange - A - must point to the same side on connecting rod and connecting rod bearing
cap
^
Installation position of connecting rod pairs
3 - Bearing shell
^
Upper bearing shell (for connecting rod) made of wear-resistant material; identification: Bright color of bearing
^
Lower bearing shell (for bearing cap) identification: Dark color of bearing
^
Check that retaining tabs are secured
^
Do not interchange used bearing shells (mark)
4 - Connecting rod
^
Only replace as set
^
Mark allocation to cylinder with paint - B -.
^
When installing bearing cap, observe: The wide thrust flange - A - must point to the same side on connecting rod and connecting rod bearing
cap
^
Installation position of connecting rod pairs
5 - Piston pin
