A4 Sedan V6-3.2L (BKH) (2007)
/Page-1002001.png)
Intake Manifold: Service and Repair
Intake Manifold Lower Section Component Overview
Intake Manifold Lower Section Component Overview
1
Intake Manifold Lower Section
‹› Removing and installing, refer to => [ Intake Manifold Lower Section with Fuel Rail ] See: Intake Manifold Lower Section With Fuel Rail.
‹› After installation, adapt both intake manifold runner position sensors in operating mode Guided Fault-Finding in "Adapting intake manifold
runner position sensor".
2
Fuel Rail
3
Fuel Pressure Sensor (G247)
4
High-Pressure Lines
CAUTION!
‹› Before opening high pressure components of the fuel injection system, pressure must be relieved to residual pressure. Refer to => [
Before Opening High Pressure Fuel Injection System ] See: Cylinder Head Assembly/Fuel Pressure Release/Service and Repair.
‹› Then wrap a clean rag around the connection and relieve residual pressure by carefully loosening the connection.
‹› Do not change bend shape
‹› Tighten high-pressure lines => [ To fasten high-pressure line (14 mm) on
fuel rail, use with. ] See: Intake Manifold Lower Section With Fuel Rail.
5
10 Nm
