A4 Sedan V6-3.2L (BKH) (2007)
-
Disconnect the Camshaft Adjustment Valve 2 (N208 ) electrical harness connector - 2 - or the Camshaft Adjustment Valve 2 (exhaust) (N319)- 3
-.
Checking internal resistance
-
Using a Multimeter, check the Camshaft Adjustment Valve for resistance.
Specified value: 5.0 to 8.0 ohms (at approx. 20° C)
If the specified value was not obtained:
-
Replace the faulty Camshaft Adjustment Valve Refer to Fuel Injection and Ignition Repair Information.
If the specified value was obtained:
Checking voltage
-
Switch the ignition on.
-
Using a Multimeter, Check the Camshaft Adjustment Valve electrical harness connector terminal 1 to the Engine Control Module (ECM) Power
Supply Relay (J271) terminal 2/87 for voltage.
-
Switch the ignition off.
Specified value: battery voltage.
If the specified value was not obtained: