A4 Sedan V6-3.2L (BKH) (2007)
Compressor Clutch: Removal and Replacement
Compressor Drive Shaft, Removing and Installing
Compressor Drive Shaft, Removing And Installing
Removing
-
Remove compressor.
-
Remove boot - A -.
-
Pull drive shaft - B - out of splines of drive pinion - C -.
Installing
Install in reverse order, paying attention to the following:
-
Check drive shaft - B -. Splines must not show signs of wear and must engage snugly in splines of drive pinion - C -.
-
Before installing, coat splines of drive shaft - B - with special grease G 000 100.
-
Before installing compressor, insert drive shaft - B - and slide it home in drive pinion - C -.
-
After installing compressor, check installation position of socket - A -.