A4 Sedan V6-3.2L (BKH) (2007)
Installing
‹› Replace circlip - A -.
‹› Clean compressor flange before sliding on belt pulley.
‹› When installing circlip - A -, note that it cannot be bent open more than is necessary for installation.
-
Install belt pulley - B -.
-
Insert circlip - A - on proper side, the side with beveled insertion edge - C - faces away from compressor (install flat side facing compressor).
-
Insert rubber element - D - in belt pulley - B - according to illustration.
-
When installing drive plate, coat rubber element - D - lightly e.g. with tire mounting paste or soap solution (as sliding compound).
-
Insert drive plate - C - far enough into rubber elements - D - until it contacts compressor shaft - B -.
-
Screw drive plate - C - onto compressor shaft - B - by rotating in direction of arrow - F -.