A4 Sedan V6-3.2L (BKH) (2007)
/Page-670009.png)
‹› The circlip - 3 - fits into the groove on the shaft and the bearing does not get damaged when the sensor wheel "I" is not installed.
-
Install marked shim - 2 - onto the shaft for the disc set "I" - 1 -.
-
Install new circlip - 3 - into the groove on the shaft for the disc set and press it in.
‹› Observe installed location: The bores in the circlips eyes are conical. The narrow side point up
‹› The circlip must contact the base of the groove.
‹› The following illustrates the intermediate housing facing upward opposite the transmission bearing.
-
Carefully tap the sensor wheel "I" and sleeve (T40131) with a rubber hammer all the way in - arrow -.
-
Carefully tap the new sensor wheel "II" and sleeve (3241) with a rubber hammer all the way in.
