audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Steering Column Switch Module, Removing and Installing|Page 771 > < Steering Column Switch Module, Removing and Installing|Page 769
Page 1
background image

Steering Mounted Controls Communication Module: Service and Repair
Steering Column Electronics Systems Control Module J527, Removing and Installing

Steering Column Electronics Systems Control Module J527 , Removing And Installing

Removing

NOTE:  Should the Steering Column Electronic Systems Control Module J527 require replacement, follow applicable component "Replacement"
procedure using VAS 5051/5051 in operating mode "Guided Fault Finding" .

-

Remove steering column switch module.

CAUTION:
-

Ensure steering is in straight ahead and centered prior to removing spiral spring.

-

Position of spiral spring must not be changed once removed.

-

Carefully release clip fasteners - arrows - and remove spiral spring - 1 - from steering column switch module.

-

Remove Steering Angle Sensor G85 - 1 - from Steering Column Electronic Systems Control Module J527 in direction of - arrow - .

-

Remove screws - arrows - .

-

Remove Steering Column Electronics Systems Control Module J527 - 1 - from steering column switch module.

Installing

Install in reverse order of removal, noting the following:

Steering Column Switch Module, Removing and Installing|Page 771 > < Steering Column Switch Module, Removing and Installing|Page 769