A4 Sedan V6-3.2L (BKH) (2007)
Seat Belt: Testing and Inspection
Checking Belt Holding Sensor For Rear Three-Point Seatbelt With Belt Tensioner
Checking Belt Holding Sensor For Rear Three-point Seatbelt With Belt Tensioner
Special tools, testers and auxiliary items required
-
Vehicle Diagnosis, Testing and Information System VAS 5051 A
-
Close Vehicle Diagnostic, Testing and Information System VAS 5051 A and tap "15 Airbag" in vehicle system selection. Ignition must be
switched on.
-
Read out display group 004 measured value block.
The belt is completely extended, display on Vehicle Diagnosis, Testing and Information System VAS 5051 A - no -.
The locking tongue is engaged in belt latch and belt has been pulled out to dimension - L -, display on Vehicle Diagnosis, Testing and Information
System VAS 5051 A - yes -.
-
Then pull belt out completely as far as stop. While pulling the belt, the display on the Vehicle Diagnosis, Testing and Information System VAS
5051 A must remain on - yes -.
-
Now unroll belt to dimension - L - without releasing the locking tongue. The display on the Vehicle Diagnosis, Testing and Information System
VAS 5051 A must remain on - yes -.
-
Release locking tongue and slowly roll belt webbing up, the display must change from - yes - to - no - at a remaining length of 100 mm at the
latest.
The belt is completely extended, display on Vehicle Diagnosis, Testing and Information System VAS 5051 A - no -.
Length - L -:
-
Length - L - on the sedan is 250 mm for the left and right belt. The belt diagonal adjuster is at the center.
-
Length - L - on the Avant is 220 mm for the left and right belt. The belt diagonal adjuster is at the center.
-
Length - L - on sedan and Avant is 500 mm for center belt.