A4 Sedan V6-3.2L (BKH) (2007)
Wiring Harness: Removal and Replacement
Primary Connector With Special Connector Systems
Primary Connector With Special Connector Systems
Procedure
NOTE: If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts.
Faston contacts:
-
Guide release tool (that fits terminal housing) into release channel on terminal housing - arrow -.
-
Grasp contact at wire and push gently into terminal housing
NOTE: By pushing contact in direction of terminal housing, contact retaining tabs are lifted off the housing shoulder and can be released using
release tool.
-
At the same time, push release tool in direction of terminal housing and pull released contact out of terminal housing - arrow -.
-
Remove release tool after removing contact from housing.
GT 150/280 contacts:
-
Guide release tool (which fits terminal housing) under retaining tab into terminal housing.
-
Push tool into terminal housing until it stops - arrow -.