A4 Sedan V6-3.2L (BKH) (2007)
Clutch Switch: Service and Repair
Clutch Pedal Switch
‹› Clutch pedal switch (F36) may only be installed once so as to ensure a firm fit.
Removing
-
Remove storage compartment on driver's side.
-
Disconnect electrical connector - 1 - on clutch pedal switch.
‹› The clutch pedal - 3 - is in the normal position (i.e. not pressed down). The operating rod - arrow - of the clutch pedal switch (F36) should then
rest against the clutch pedal.
-
Release clutch pedal switch (F36) - 2 - by turning 45 degrees counterclockwise and remove from guide.
Installing
Installation is perform in reverse sequence. Note the following:
-
Pull out operating rod - arrow - all the way before installing clutch pedal switch (F36).
‹› The clutch pedal should be in the normal position (i.e. not pressed down).