A4 Sedan V6-3.2L (BKH) (2007)
/Page-1759002.png)
‹› Bolts must be installed flush to 25 Nm => Assembly instructions for pressure stand (T40099).
-
Insert input shaft in pressure stand (T40099).
-
Rotate seal ring extractor (T40014) by hand into shaft seal until the tool has a good hold in the shaft seal. Then tighten puller with an open-end
wrench.
-
You can pull out shaft seal a short distance by screwing in rear screw - arrow -.
-
Re-tighten Seal ring extractor (T40014) so that puller engages securely in shaft seal again and continue turning screw to pull out shaft seal.
-
Repeat procedure until shaft seal has been pulled out completely.
-
Remove input shaft cover circlip - A -.
