A4 Sedan V6-3.2L (BKH) (2007)
Input Shaft: Procedures
Input Shaft Adjustment, Air Gap, Checking
CAUTION!
Do not allow engine to run without filling ATF and do not tow the vehicle.
‹› ATF filled
-
Drive vehicle off hoist.
‹› On vehicles with air suspension, vehicle lifting mode must be deactivated.
‹› ATF filled
-
Place vehicle on level surface.
‹› With parking brake released, vehicle may roll forward or backward by itself when in selector lever position "N".
-
Start engine.
-
Place selector lever in position "N".
‹› Do not engage parking brake.
‹› Do not operate brake pedal.
-
Press accelerator.
‹› Vehicle should not be allowed to roll.
If vehicle rolls in selector lever position "N ":
-
Adjust selector lever cable.
If selector lever cable adjustment is OK but vehicle still rolls in selector lever position "N":
-
Input shaft, servicing => [ Input Shaft, Servicing with 6 Lining Discs ] See: Overhaul/01J,0AN Transmission/Input Shaft, Servicing With 6 Lining
Discs or => [ Input Shaft, Servicing with 7 Lining Discs ] See: Overhaul/01J,0AN Transmission/Input Shaft, Servicing With 7 Lining Discs
‹› In this case, input shaft adjustment (air gap) was not performed correctly.
If vehicle does not roll in selector lever position " N":
The input shaft adjustment with evaluation of air play is OK.
-
Carry out ATF flush => [ First test run pass through: ] See: Continuously Variable Transmission/Transaxle/Fluid - CVT/Service and
Repair/01J,0AN Transmission/ATF Flush