A4 Sedan V6-3.2L (BKH) (2007)
Shift Interlock Cable: Service and Repair
Locking Lever (Through VIN 8E_6A156499), Removing and Installing
Locking lever (through VIN 8E_6A156499), removing and installing - 01J, Continuously Variable Transmission (CVT)
1- Locking cable
Removing
Note:
^
Do not kink locking cable.
CAUTION!
Observe procedures for disconnecting battery.
-
Disconnect Ground (GND) wire at battery.
-
Remove storage compartment on drivers side.
-
Remove steering column trim.
-
Remove A/C system operating unit.
-
Remove ashtray in center console.
-
Remove cover for shift mechanism.
-
Turn ignition key into driving position ( "ignition on" ).
-
Place selector lever in position "P".
-
Lift retaining clip -2- from interlock lever and pull locking cable -1- out of ignition/starter switch.
-
Lift securing spring -4- for locking cable and pull locking cable support bracket -5- on shift mechanism sideways and disengage locking cable eye.