A4 Sedan V6-3.2L (BKH) (2007)
/Page-2000001.png)
Transmission Cooler: Removal and Replacement
ATF Cooler, Pipes and Filter General Repair Information
ATF Cooler, Pipes and Filter General Repair Information
‹› Rules of cleanliness for working on transmissions. Refer to => [ Clean Working Conditions ] See: Service Precautions/01J Transmission/Clean
Working Conditions.
‹› General repair information. Refer to => [ General Repair Information ] See: Service and Repair/Procedures/01J Transmission/General Repair
Information.
‹› Always blow compressed air through the Automatic Transmission Fluid (ATF) cooler and pipes (max. 10 mbar) and replace the auxiliary ATF
filter before installing a replacement transmission. Refer to => [ ATF Cooler and Pipes Cleaning ] See: Procedures/01J Transmission. If extremely
dirty ATF flows out when blowing with compressed air, the ATF cooler and pipes must also be flushed with clean ATF.
‹› To install, first insert the ATF pipes into the transmission or cooler by hand as far as they will go, then bolt on.
‹› Check the ATF level after replacing the ATF pipes. Refer to => [ ATF Level Checking ] See: Fluid - CVT/Service and Repair/01J
Transmission/ATF Level Checking.
