A4 Sedan V6-3.2L (BKH) (2007)
/Page-2054003.png)
-
Circlip must engage audibly, triple roller star must lie against circlip with no gap.
-
Install circlip.
1
Pliers (commercially available)
-
Press 70 grams of joint grease, from repair kit, into the reverse side of the triple roller joint.
-
Lightly lubricate roller body
Make sure roller body does not tilt!
-
Press joint over triple roller start with plastic hammer
Drive axle AAR 3300 i Assembly Device (T40018) is shown in illustration.
-
Press remaining quantity of grease in protective boot.
-
Make sure that correct seating of boot on joint.
-
Boot must fit in groove and on joint contour
-
Position joint in center position. See min - max position
