A4 Sedan V6-3.2L (BKH) (2007)
/Page-2050003.png)
-
Using bolts - arrows -, align CV joint boot with cap in relation to bolt holes.
The alignment must be very accurate, because no further alignment is possible once the cap has been hammered on.
-
Drive on CV joint boot with cap using a plastic hammer.
-
Remove surplus sealant immediately as it is pressed out.
-
Using bolts - arrows -, align new cover in relation to bolt holes.
The alignment must be very accurate, because no further alignment is possible once the part has been hammered on.
-
Drive on cover using a plastic hammer.
-
Remove surplus sealant immediately as it is pressed out.
