A4 Sedan V6-3.2L (BKH) (2007)
3 - Clamp
‹› Always replace
4 - Securing ring
‹› Only present on certain versions
5 - Dished washer
‹› Only present on certain versions
‹› Installed position => [ Location of spacer and spring washer (wheel side) ]
6 - Spacer ring (plastic)
‹› Only present on certain versions
‹› Installed position => [ Location of spacer and spring washer (wheel side) ]
7 - Securing ring
‹› Always replace
‹› Insert before mounting in ring groove (not visible with joint installed)
8 - Outer constant velocity joint
‹› Replace only as complete unit
‹› Pressing off => [ Driving outer CV joint down ]
‹› Installing:
‹› Drive joint onto shaft with a plastic hammer until circlip engages.
‹› Greasing => [ Peened Triple Roller Joint AAR 2600 i or 3300 i Assembly Overview ] See:
‹› When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
9 - Bolt
‹› Always replace after removal
‹› Loosen => [ Remove drive axle ] See: Service and Repair/Removal and Replacement/Front Suspension
‹› Fastening => [ Install drive axle ] See: Service and Repair/Removal and Replacement/Front Suspension
‹› Tightening specification => [ Install drive axle ] See: Service and Repair/Removal and Replacement/Front Suspension
10 - Clamp
‹› Different versions for protective joint boot in rubber or Hytrel
‹› Replace
11 - CV boot for outer constant velocity (CV) joint
‹› Check for tears and scuffing
‹› Before clamping hose clamps, raise protective joint boot briefly to balance pressure => [ Venting CV boot ]
‹› Different version in rubber or Hytrel.
12 - Clamp