A4 Sedan V6-3.2L (BKH) (2007)
/Page-2092002.png)
-
Insert completely assembled pinion shaft into transmission housing again.
-
Install bearing housing and transmission cover and tighten bolts to 35 Nm.
-
Turn pinion shaft 5 turns in each direction so that taper roller bearings seat properly.
-
Install assembly device (VW 792) on transmission housing; when doing so, insert an M12 nut - A - between assembly device (VW 792) and
transmission housing.
-
Attach universal dial gauge bracket (VW 387) with dial gauge and 30 mm extension.
‹› Attach dial gauge extension exactly at the center of the webbing intersection on the transmission cover - arrow -.
-
Set dial gauge (3 mm measuring range) to "0" with 1 mm preload.
-
Loosen transmission cover bolts and turn pinion shaft several times.
-
If correct shims have been selected the dial gauge will now indicate the following value:
‹› 0.06 to 0.12 mm
If this reading is not obtained, the adjustment must be corrected.
