A4 Sedan V6-3.2L (BKH) (2007)
/Page-2103004.png)
-
Support tunnel crossmember (rear) using engine and transmission jack (VAG 1383 A).
-
Remove bolts - 1 - and - 2 -, then bolts - 3 - and - 4 -.
-
Carefully lower tunnel crossmember (rear) using engine and transmission jack (VAG 1383 A) until distance between crossmember (rear) and body
reaches dimension "x".
‹› Dimension x = 60 mm
-
Remove heat shield - arrow - for drive axle (right side) and, if installed, also for drive axle (left-side).
-
Remove connecting rod - 2 - for selector rod.
