A4 Sedan V6-3.2L (BKH) (2007)
/Page-2103005.png)
-
Detach push rod - 1 -; to do so, remove bolt.
-
Remove nut - arrow - and remove selector shaft lever from selector shaft.
-
Remove selector rod to rear.
Installing
Installation is perform in reverse sequence. Note the following:
‹› Always replace seals, gaskets and self locking nuts.
-
Install tunnel crossmember.
-
Install exhaust system.
-
Adjust gear lever. Refer to => [ Gear Lever Adjusting ] See: Adjustments.
-
Install operating and display unit for air conditioner.
Tightening Specifications
