A5
|
Caution
Note| t | Apply grease -G 000 450 02- to all bearings and contact surfaces. |
| t | Make sure that no brake fluid escapes into the footwell, the plenum chamber or onto the gearbox below. If this does happen, clean the affected area thoroughly. |
| 1 - | Mounting bracket |
| q | With brake pedal |
| q | Removing and installing → Chapter |
| 2 - | Bearing bush |
| 3 - | Clutch pedal |
| q | Removing and installing → Chapter |
| 4 - | Clutch pedal stop |
| 5 - | Locking pin |
| q | For clutch master cylinder |
| 6 - | Pivot pin for clutch pedal |
| 7 - | Bearing shell |
| q | Located in clutch pedal |
| 8 - | Over-centre spring |
| q | Black side points towards clutch pedal |
| q | Note different bearing positions in mounting bracket → Anchor |
| q | Removing and installing → Chapter |
| q | For correct version, refer to → Electronic parts catalogue |
| 9 - | Bearing shell |
| q | Note different bearing positions in mounting bracket → Anchor |
| 10 - | Seal |
| q | Renew |
| 11 - | Clutch master cylinder |
| q | Removing and installing → Chapter |
| 12 - | Clutch position sender -G476- |
| q | Clutch pedal switch -F36- and clutch pedal switch for engine start -F194- are integrated |
| q | Can only be renewed together with clutch master cylinder → Item |
