Audi Workshop Service and Repair Manuals

Renewing flange shaft oil seal (right-side) with gearbox removed   Note The flange shaft oil seal (right-side) can also be renewed with the gearbox installed in the vehicle → 6-speed manual gearbox 0B2, four-wheel drive; Rep. Gr.39. Special tools and workshop equipment required

t  Drift -VW 295-

t  Puller -T10037-

t  Thrust piece -T40163- t  Sealing grease -G 052 128 A1-

Removing –  Remove flange shaft (right-side); to do so, secure puller -T10037- to gearbox housing -arrow-.

–  Lever out flange shaft oil seal using an assembly lever. Installing Installation is carried out in reverse sequence; note the following:

–  Always renew circlip for flange shaft -A-. –  Clamp flange shaft in vice, using jaw protectors. Use new circlip -A- to press old circlip out of groove in flange shaft.

–  Lightly oil outer circumference of new oil seal. –  Drive in new flange shaft oil seal (right-side) as far as stop; keep seal straight when installing. –  Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-. –  Knock flange shaft in with drift -VW 295-.

–  Unscrew oil filler plug -arrow-, fill up gear oil in gearbox and check oil level → 6-speed manual gearbox 0B2, four-wheel drive; Rep. Gr.34.