audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing oil level and oil temperature senderG266 > < Sump (bottom section), sump (top section), oil pump, engine oil cooler - exploded view

A5

Removing and installing engine oil cooler
Removing and installing engine oil cooler
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
  W00-10211
Removing
–  Remove front noise insulation -1- → Rep. gr.66.
–  Drain coolant → Chapter (or on vehicles equipped with continued coolant circulation pump -V51- remove continued coolant circulation pump → Chapter).
  A10-11071
–  Remove bolt -1- and nut -3- and detach strut -2- (left-side) for lock carrier.
  A10-10844
–  Detach coolant hose -1- and, if necessary, -2- from engine oil cooler; release hose clip to do so.
–  Position used oil collection and extraction unit -V.A.G 1782- below engine.
–  Unscrew bolts -arrows- and detach engine oil cooler.
Installing
Installation is carried out in the reverse order; note the following:
l  Tightening torques → Chapter „Sump (bottom section), sump (top section), oil pump, engine oil cooler - exploded view“
  Note
t  Renew gasket.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
–  Install strut for lock carrier → Rep. gr.50.
–  Install continued coolant circulation pump -V51- → Chapter.
–  Check oil level → Booklet811, → Booklet812 or → Booklet818.
–  Fill up with coolant → Anchor.
  A17-10053

Removing and installing oil level and oil temperature senderG266 > < Sump (bottom section), sump (top section), oil pump, engine oil cooler - exploded view