A5
| Turbocharger - exploded view |
| 1 - | Connecting pipe |
| q | To change-over flap for exhaust gas recirculation cooler |
| 2 - | Gasket |
| q | Renew |
| 3 - | Intermediate flange |
| q | Removing and installing → Chapter |
| 4 - | Bolt |
| q | 25 Nm |
| 5 - | Coolant pipe (rear right) |
| q | Exploded view → Chapter |
| 6 - | O-ring |
| q | Renew |
| 7 - | Bolt |
| q | 9 Nm |
| 8 - | Oil supply line |
| q | From cylinder block |
| 9 - | Bolt |
| q | Depending on version |
| q | 9 Nm |
| 10 - | Bolt |
| q | Depending on version |
| q | 9 Nm |
| 11 - | Seals |
| q | Renew |
| 12 - | Banjo bolt |
| q | 15 Nm |
| 13 - | Air pipe (right-side) |
| 14 - | Hose clip |
| q | Reinforced |
| q | 5.5 Nm |
| 15 - | Air hose |
| q | From turbocharger to air pipe (right-side) |
| 16 - | Hose clip |
| q | Reinforced |
| q | 5.5 Nm |
| 17 - | Bolt |
| q | 9 Nm |
| 18 - | Connecting piece for air intake hose |
| q | From air mass meter -G70- to turbocharger |
| q | Must be free of oil or grease when installing |
| 19 - | Exhaust gas temperature sender 1 -G235- |
| q | Removing and installing → Chapter |
| 20 - | Seal |
| q | Renew if damaged |
| 21 - | Bolt |
| q | 9 Nm |
| 22 - | Heat shield for turbocharger |
| 23 - | Turbocharger |
| q | With turbocharger 1 control unit -J724- |
| q | Removing and installing turbocharger → Chapter |
| q | Removing and installing turbocharger 1 control unit -J724- → Chapter |
| 24 - | Bolt |
| q | Renew |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| q | 30 Nm + turn 90° further |
| 25 - | Gasket |
| q | Renew |
| 26 - | Particulate filter |
| q | Removing and installing: A5 up to vehicle identification no. 8T-8-009 998 → Chapter; A4 (all), A5 from vehicle identification no. 8T-8-009 999 onwards → Chapter |
| 27 - | Nut |
| q | Tightening torque → Item |
| 28 - | Gasket |
| q | Renew |
| 29 - | Bolt |
| q | Coat with high-temperature paste; for high-temperature paste refer to → Electronic parts catalogue |
| q | Initially tighten to 7 Nm. |
| q | 9 Nm |
| 30 - | Top section of oil return line |
| q | From turbocharger |
| 31 - | Bolts |
| q | 9 Nm |
| 32 - | Bottom section of oil return line |
| q | To cylinder block |
| 33 - | O-rings |
| q | Renew |
| 34 - | Seal |
| q | Renew |
| 35 - | Intermediate pipe |
| q | Removing and installing: left-side → Chapter, right-side → Chapter |
| 36 - | Bolt |
| q | Tightening torque → Item |
| 37 - | Gasket |
| q | Renew |
| 38 - | Bolt |
| q | 25 Nm |
| 39 - | Bolt |
| q | Tightening torque → Item |
