Rules for cleanliness and instructions for working on fuel system |
WARNING The fuel system operates at extremely high pressure. This can cause injury. |
t
| The fuel system is pressurised. The fuel pressure in the high-pressure section of the injection system must be reduced to a residual pressure prior to opening; for procedure see → Chapter. |
t
| The connection must be opened immediately after reducing the pressure; wrap a cloth around the connection and allow the residual pressure (approx. 7 bar) to dissipate. |
|
Caution To prevent irreparable damage to the electronic components when disconnecting the battery: |
Observe notes on procedure for disconnecting the battery. |
|
Even small amounts of dirt can cause malfunctions. For this reason, please observe the following rules when working on the fuel supply system and injection system: |
t
| Carefully clean connection points and the surrounding area with engine cleaner or brake cleaner and dry thoroughly before opening. |
t
| Plug open lines and connections with suitable protective caps immediately. |
t
| Place parts that have been removed on a clean surface and cover them over. Do not use fluffy cloths. |
t
| Only install clean components; replacement parts should only be unpacked immediately prior to installation. Do not use parts that have been previously unpacked and stored away loose (e.g. in toolboxes, etc.). |
t
| When the system is open: Do not work with compressed air. Do not move the vehicle unless absolutely necessary. |
t
| Protect unplugged electrical connectors against dirt and moisture and make sure connections are dry when attaching. |
|
|
|