audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Bleeding steering system after repairs > < Checking fluid level, bleeding steering system and checking for leaks

A5

Checking fluid level of power steering
Checking fluid level of power steering
–  Do not start engine. Set front wheels to straight-ahead position.
When fluid is cold (approx. 20°C):
–  Unscrew filler cap.
–  Wipe dipstick with a clean cloth.
–  Screw filler cap on hand tight and unscrew again.
  Note
The cap must first be fully screwed on in order to obtain an accurate fluid level reading.
   
–  Check fluid level: fluid level should be in area -A-.
When fluid is at operating temperature (approx. 80 °C):
–  Unscrew filler cap.
–  Wipe dipstick with a clean cloth.
–  Screw filler cap on hand tight and unscrew again.
  Note
The cap must first be fully screwed on in order to obtain an accurate fluid level reading.
  A48-10064
–  Check fluid level: fluid level should be in area -B-.
  Note
t  Excess fluid must be drained off if the level is above the range specified above.
t  If the fluid level is below the range specified, the hydraulic system must be checked for leaks. In this case it is not sufficient to merely top up the fluid.
t  Do not re-use hydraulic fluid which has been drained off.
  A48-10064

Bleeding steering system after repairs > < Checking fluid level, bleeding steering system and checking for leaks