A5 Quattro Coupe V6-3.2L (CALA) (2009)
/Page-711002.png)
-
Remove bolts - arrows - and the balance shaft and bearing end bracket at the rear of the engine.
-
Remove balance shaft back out of the cylinder block.
Installing
‹› Tightening specifications. Refer to => [ Balance Shaft Assembly Overview ] See: Balance Shaft Assembly Overview, => [ marking locking bolt -
Tightening Specification ] See: Cylinder Block Assembly/Crankshaft/Service and Repair/Crankshaft Assembly Overview.
‹› Secure crankshaft - 1 - in "TDC" position using Locking Pin (T40069).
