Audi Workshop Service and Repair Manuals > A5 Quattro Coupe V6-3.2L (CALA) (2009) > Engine, Cooling and Exhaust | Engine | Timing Components | Timing Chain | Component Information | Service and Repair | Camshaft Timing Chains, Removing From Camshafts

Camshaft Timing Chains, Removing From Camshafts|Page 2572 > < Camshaft Timing Chains, Removing From Camshafts|Page 2570

Page 4

Remove locking bolt - arrow - for the "TDC " marking from the cylinder block.

‹› The crankshaft locating hole is difficult to find when the engine is installed.

‹› Rotate the engine until the small notch - 1 - on the vibration damper aligns at the left of the housing separation point - 2 - between the cylinder

block and the guide frame. This makes it easier to install the Locking Pin (T40069).

‹› The marking on the vibration damper is only there to help. The exact " TDC" location is only reached by installing the Locking Pin (T40069).

‹› The threaded holes - arrows - in the camshafts must face upward.

Engine, Cooling and Exhaust
Engine
Timing Components
Timing Chain / Service and Repair / Camshaft Timing Chains, Removing From Camshafts
Page 2571

Camshaft Timing Chains, Removing From Camshafts|Page 2572 > < Camshaft Timing Chains, Removing From Camshafts|Page 2570

Audi Workshop Service and Repair Manuals

A5 Quattro Coupe V6-3.2L (CALA) (2009)

Engine, Cooling and Exhaust Engine Timing Components Timing Chain / Service and Repair / Camshaft Timing Chains, Removing From Camshafts Page 2571

Engine, Cooling and Exhaust Engine Timing Components Timing Chain / Service and Repair / Camshaft Timing Chains, Removing From Camshafts Page 2571

Engine, Cooling and Exhaust
Engine
Timing Components
Timing Chain / Service and Repair / Camshaft Timing Chains, Removing From Camshafts
Page 2571

Engine, Cooling and Exhaust
Engine
Timing Components
Timing Chain / Service and Repair / Camshaft Timing Chains, Removing From Camshafts
Page 2571