A5 Quattro Coupe V6-3.2L (CALA) (2009)
-
Remove the headlamp range adjustment positioning motor - 1 - by the left headlamp clockwise - arrow A - and by the right headlamp
counterclockwise.
-
Disengage positioning motor from headlamp housing.
-
Slide the adjusting axle ball head - 4 - out of the ball socket - 3 - by tilting the positioning motor - 1 - upward - arrow B -.
-
Press reflector forward and remove adjusting motor.
Installing
‹› Tightening specification, refer to => [ Halogen Headlamps Assembly Overview, from 11.2008 ] See: Service and Repair/Halogen Headlamps
Assembly Overview, from 11.2008.
Install in reverse order of removal, observing the following:
-
Insert the adjusting axle ball head into the reflector ball socket from above while pulling the reflector back.
-
Position the headlamp range adjustment positioning motor bayonet connection on the headlamp housing.
-
Engage the headlamp range adjustment positioning motor counterclockwise on the left headlamp and clockwise on the right headlamp.
-
Connect the electrical connector on the headlamp range adjustment positioning motor.
-
Close the housing cover and secure it the spring clip.
-
Install the headlamp housing, Refer to => [ Headlamp Housing ]. See: Service and Repair/Halogen Headlamps, from 11.2008/Headlamp Housing