A5 Quattro Coupe V6-3.2L (CALA) (2009)
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to Battery (+), or an open circuit.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Replace the Motronic Engine Control Module (ECM) (J623). Refer to the appropriate service information.
-
Install the right vehicle floor cover - arrows -. Refer to the appropriate service information.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 01 - 09/Diagnostic Mode 03 - Read DTC Memory.