audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Customer Interest for Oil Level Warning Indicator Control Module:|961014|Page 207 > < Radiator Cooling Fan Control Module|Service and Repair|Page 200
Page 1
background image

Oil Level Warning Indicator Control Module: Customer Interest
Instruments - 'Low Oil Level Message' Displayed

96 Oil warning in DIS or MMI

96 10 14 

2023967/2 

October 28, 2010

Supersedes Technical Service Bulletin Group 96 number 10-12 dated September 8, 2010 for reasons listed below.

AFFECTED VEHICLES

CONDITION

Message in MMI reads: Low Oil Level."

TECHNICAL BACKGROUND

The hood must be open for at least 30 seconds fora reset of this message to be performed. The message is not reset in the DIS/MMI because the hood has
not been recognized as being opened due to an inoperative hood contact switch.

PRODUCTION SOLUTION

Improved hood contact switches have been put into current production vehicles, and a software change with improved logic is planned for production.

SERVICE

Check hood contact switch: Use the VAS diagnostic tester to read MVB 26 in the J393 - Comfort System Control Module (address code 46) after the
hood is opened and closed.

^ If the value does not change, then replace only the contact switch. Follow the applicable work instructions listed in ElsaWeb for replacing the hood

contact switch.

Tip: Do not replace the complete hood latch assembly. Replace only the micro-switch.

Customer Interest for Oil Level Warning Indicator Control Module:|961014|Page 207 > < Radiator Cooling Fan Control Module|Service and Repair|Page 200