A5 Quattro Coupe V6-3.2L (CALA) (2009)
Discharge Air Temperature Sensor / Switch: Service and Repair
Evaporator Vent Temperature Sensor
Evaporator Vent Temperature Sensor
Removing
-
Move the passenger seats as far back as possible.
-
Switch off ignition.
-
Remove glove compartment.
-
Removing right passenger footwell vent. Refer to => [ Right Footwell Door Motor ] See: Heating and Air Conditioning/Air Door/Air Door
Actuator / Motor/Service and Repair/Removal and Replacement
-
Disconnect the electrical connection - A -.
-
Loosen the Evaporator Vent Temperature Sensor (G263)- B - from the A/C bracket - C -
-
Turn the Evaporator Vent Temperature Sensor (G263) - B - 180° and remove it from the A/C.
‹› The Evaporator Vent Temperature Sensor (G263) - B - is installed so that the temperature sensor - D - is facing the evaporator. To remove and
install it when the air intake housing is installed, it must be turned it its mount 180° out of installation position after loosening or before tightening.
Installing
Installation is carried out in the reverse order, when doing this note the following.
-
Loosen the Evaporator Vent Temperature Sensor (G263)- B - from the A/C bracket - C -.
-
Turn the Evaporator Vent Temperature Sensor (G263) - B - 180° and the mount it in the bracket.
-
Install the removed parts in the opposite order.
-
Check DTC memory of A/C control head Climatronic Control Module (J255) and erase any displayed malfunction if necessary. Refer to Vehicle
Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.