A5 Quattro Coupe V6-3.2L (CALA) (2009)
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures.
7
Bolt
‹› Always replace after removal
8
Washer
9
Wheel bearing housing
10
Nut
‹› 40 Nm
‹› Always replace after removal
11
Upper front control arm
‹› Removing and installing => [ Upper Control Arm ] See: Control Arm/Service and Repair/Front Suspension/Upper Control Arm.
12
Bolt
‹› 50 Nm + an additional 90° turn
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures.
13
Nut
‹› Always replace after removal
14
Nut
‹› 90 Nm + an additional 90° turn
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures.
15
Bolt
‹› Always replace after removal
16
Control arm
17
Bolt
‹› 40 Nm + an additional 90° turn
‹› Always replace after removal
‹› Must be tightened in curb weight position => [ Lifting to Curb Weight Position ] See: Wheel Bearing/Service and Repair/Procedures.
18
Coupling rod
‹› Note installed position => [ Connecting Link ] See: Suspension Strut / Shock Absorber/Service and Repair/Removal and Replacement/Front
Suspension/Connecting Link.
19
Shock absorber fork
‹› Removing and Installing => [ Shock Absorber Fork ] See: Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Front Suspension/Shock Absorber Fork.