A5 Quattro Coupe V6-3.2L (CALA) (2009)
Installing
Install in reverse order, paying attention to the following:
-
Apply ATF to the circumference and the space between the sealing lips of the new shaft seal.
‹› Installation position: Open side of shaft seal faces transmission.
-
Slide shaft seal onto the selector shaft.
-
Press new shaft seal on as far as the stop using the thrust piece (T10135) and assembly lever - A -. Make sure the shaft seal does not tilt when
doing this.
-
Drive spring pin back onto removed selector shaft lever in opposite direction to lever.
-
Slide lever onto the selector shaft and drive in the spring pin.
-
Check the ATF level. Refer to => [ ATF Level, Checking ] See: Fluid - A/T/Service and Repair/ATF Level, Checking.