A5 Quattro Coupe V6-3.2L (CALA) (2009)
/Page-1252002.png)
‹› This marking - arrow - is needed so the colored point - C - on the outer flange remains in its original position.
‹› This ensures the imbalance in the rear final drive will be as small as possible.
-
Install the 2 bolts M 8 x 30 - arrow - in the flange.
-
Remove the flange/driveshaft using the Puller (VW 391).
-
Carefully press the seal in slightly at the top of the outer circumference - arrow -.