A5 Quattro Coupe V6-3.2L (CALA) (2009)
Drive/Propeller Shaft: Service and Repair
Driveshaft, Removing and Installing from Transmission
Driveshaft, Removing and Installing from Transmission
Special tools, testers and auxiliary items required
‹› Counterhold tool (T10172) with adapters (T10172/5)
‹› High temperature grease (G 000 633)
Removing
‹› See notes, refer to => [ Driveshaft Assembly Overview ] See: Driveshaft Assembly Overview.
‹› A twin pillar vehicle hoist should be used when working on the driveshaft.
‹› Flex joint in front exhaust pipe must not be bent more than 10 °, otherwise it may be damaged.
-
Loosen the clamp(s) - arrows - and separate the exhaust system.
-
Tie up the exhaust pipe(s) to the floor panel.
-
Remove the heat shield - A - from the transmission- arrows -, if applicable.